Samsung SMH9207ST Installation Manual

The Samsung SMH9207ST is a high-performance over-the-range microwave oven with 1.9 cubic feet capacity, 1000 watts cooking power, sensor cooking technology, ceramic enamel interior, LED lighting, and ventilation system. This manual provides comprehensive installation instructions for proper setup and operation. Below are key sections for safety, installation requirements, step-by-step installation, electrical requirements, and troubleshooting.

1. Installation Requirements 2. Tools and Materials Needed 3. Step-by-Step Installation 4. Electrical Requirements 5. Ventilation Options 6. Mounting Specifications 7. Safety Precautions 8. Final Setup and Testing 9. Troubleshooting

Installation Requirements

Before installation, ensure you meet all requirements for proper mounting and operation.

RequirementSpecification
Cabinet SpaceMinimum 30 inches width between cabinets
Mounting HeightBottom of microwave 66 inches from floor
Ventilation ClearanceMinimum 12 inches above cooktop
Electrical Outlet120V, 60Hz, 15-amp dedicated circuit
Wall SupportMust support 150 lbs minimum
Ventilation PathVertical or horizontal duct options

Tools and Materials Needed

Gather all necessary tools and materials before beginning installation.

  1. Phillips screwdriver
  2. Drill with 1/4-inch and 3/8-inch bits
  3. Measuring tape
  4. Level
  5. Pencil
  6. Stud finder
  7. Safety glasses
  8. Mounting template (included)
  9. Ventilation duct kit (if external venting)

WARNING! Wear safety glasses during installation to protect eyes from debris.

Step-by-Step Installation

Follow these steps carefully for proper installation.

  1. Prepare the area: Remove old microwave if present. Clean mounting surface.
  2. Locate studs: Use stud finder to locate wall studs for secure mounting.
  3. Position template: Tape mounting template to wall at correct height.
  4. Drill holes: Mark and drill holes for mounting plate according to template.
  5. Install mounting plate: Secure plate to wall using provided screws and wall anchors.
  6. Prepare microwave: Remove grease filters and installation hardware from package.
  7. Lift and mount: With assistance, lift microwave and hook onto mounting plate.
  8. Secure unit: Attach microwave to cabinet bottom using provided screws.
  9. Connect power: Plug into dedicated electrical outlet.
  10. Test operation: Verify all functions work properly.

CAUTION! Microwave is heavy; use two people for lifting and mounting.

Electrical Requirements

WARNING! Do not use extension cords. Ensure proper grounding.

Ventilation Options

The SMH9207ST offers three ventilation modes.

ModeDescriptionRequirements
External VentingVents to outside3.25 x 10 inch duct, roof or wall cap
RecirculatingVents back into kitchenCharcoal filter (included)
Vertical VentingVents upwardRoof cap, vertical duct work

Tip: External venting provides best performance for smoke and odor removal.

Mounting Specifications

Detailed mounting measurements and clearances.

Safety Precautions

Critical safety information for installation and operation.

  1. Disconnect power before installation
  2. Ensure wall can support microwave weight
  3. Maintain proper clearance from cooktop
  4. Use proper ventilation to prevent heat buildup
  5. Do not install over gas cooktops without minimum 30-inch clearance
  6. Keep flammable materials away from ventilation system

WARNING! Failure to follow safety precautions may result in fire or injury.

Final Setup and Testing

Complete installation with final checks and testing.

  1. Verify all screws are tight and secure
  2. Check that microwave is level
  3. Install grease filters properly
  4. Set ventilation mode (external/recirculating)
  5. Plug into electrical outlet
  6. Test all functions: power, timer, ventilation, lighting
  7. Verify door closes securely and latches properly
  8. Check for any unusual noises or vibrations

Tip: Run ventilation on high speed for 10 minutes to clear any installation debris.

Troubleshooting

ProblemPossible CauseSolution
Microwave not turning onPower issueCheck outlet, circuit breaker, and power cord connection
Poor ventilationBlocked duct or filterClean grease filters, check duct for obstructions
Vibration noiseLoose mountingTighten all mounting screws and brackets
Door not closingMisalignmentAdjust door hinges and check for obstructions
Light not workingBulb or connectionReplace LED bulb, check electrical connections

Service: For technical support, contact Samsung at 1-800-SAMSUNG or visit www.samsung.com

Samsung SMH9207ST Installation Manual © - All Rights Reserved 2025